Please refer to the following if you need to install / re-seat the SD card or SIM card:




Required Tools:

Specialty screwdriver (included in the Navistream camera box).


Instructions: 


1. Access the Side Panel


  • Locate the small access panel on the side of the camera unit.
  • Use your screwdriver to remove the screw(s) holding the protective cover in place.
  • Carefully remove the cover and set it aside.


2. Identifying the Slots


  • Inside the compartment, you will see two slots:
    • SD Card Slot: Usually the larger slot.
    • SIM Card Slot: Usually the smaller slot.


3. Removing/Re-seating the Cards


  • To remove: Use your fingernail or a small flat tool to gently press the card inward until it "clicks." It will then spring out slightly, allowing you to pull it out.
  • To re-install: Ensure the gold contact pins are facing the correct direction (typically facing toward the main body of the camera, but refer to the icons etched next to the slots if visible).
  • Insert the card into the slot and press it firmly until you hear/feel a click, indicating it is locked in place.
    • Note: If you are re-seating because of a "No SD Card" error, ensure the card is clean and free of debris before re-inserting it.


4. Final Steps


  • Once the cards are securely clicked into their slots, place the protective cover back over the compartment.
  • Replace and tighten the screws to ensure the compartment is sealed against dust and vibration.
  • Power on the device to ensure the camera recognizes the storage (SD) and connectivity (SIM).